of free benefits only
available to members
REO is an original manufacturer of high quality power equipment, including electronic controllers, components and electrical regulators.
Knowledge Base TOP 5
REOVIB R15/469 110 V, max. 15 Amp Panel Mounting Version (IP00) I/D 46920
The REOVIB R15/469 range of units are used to control the throughput of vibratory feeders with an electromagnetic drive. The power is controlled by using thyristors operating with the phase-angle principle. The set point is adjusted using either the potentiometer, or a voltage or current signal. The internal trimmer pots “Umin“ and “Umax“ are used to adapt to the feeder’s specific characteristics. An enable input is provided for switching the unit from supervisory systems such as a PLC. A soft-start is provided to prevent surges when the unit is switched on. These units work as regulators, with either the output voltage or the amplitude of the feeder maintained at a constant level. When using the unit as an amplitude regulator it is necessary to fit a sensor on the feeder to measure the amplitude or, alternatively, the acceleration (e.g. sensor type REOVIB SW 07). An internal switch is used for selecting the output regulation mode or amplitude regulation mode. A status relay is available as an option. The relay switches when there is no output voltage or no feedback signal from the sensor. The internal semiconductors are protected against short-circuit by an integrated fuse. The unit is supplied with a mains switch, an input fuse and input cable.
Send an enquiry about this product
Data Sheets
46920_ins_1.pdf file size: 544kb
Instructions
46920_ins.pdf file size: 544kb
